Black Widow Security BW X-Z Series Manual de instalación descargar pdf (Pagina 3)

INSTALLATION

INSTRUCTIONS:

1. Mount the Siren:

Locate a suitable place under the hood,

away from hot and moving engine parts

such as manifolds, turbo chargers, fan

belts, etc. Secure siren by screwing brack-

et to a solid location under the hood.

Make sure that there is no outside access

to both siren and wire from underneath

the vehicle or through the grill.

Point the siren down so that water may

not accumulate inside the siren bell.

Ground the black wire of the siren to a

solid ground; preferably, use a star washer

and ring terminal.

When running wires inside the vehicle,

use either tape or split loom tubing.

Always use either existing grommets or if

a new hole is needed protect the wire

from chaffing by installing a proper size

grommet.

2. Install the Status

Indicator (LED):

(Optional)

Locate a suitable place for the status indi-

cator (LED), drill the appropriate size

hole (7/16”). Make sure there is enough

depth for the LED to fit all the way in,

and can be easily seen from outside the

vehicle. Carefully run the LED and 2 pin

red connector and wire harness to the

module and plug into the matching red

two pin connector on the module. Push

the LED into the hole, it should fit snugly.

3. Connect Starter

Disable Relay:

(Optional)

Using a volt/ohm meter locate the starter

wire (normally a heavier gauge wire) off

of the ignition switch.The meter will read

12V+ only during cranking.When the

starter wire has been located, cut the

wire, the vehicle should not be able to

start now. Connect the gray wire to a

relay (See starter disable relay on page 5

).

4. Connect Negative door

input: Blue wire on main har-

ness

(Optional)

Connect the blue wire from the harness

to the wire that shows ground when all

of the doors are opened.Verify with a

volt/ohm meter. Make sure that all doors

when opened separately make the target

wire provide a ground output.

5. Connect Hood/ Trunk switch

input:Blue wire on main har-

ness

(Optional)

Connect the blue wire to either or both

hood and trunk switches.They must pro-

vide a ground output when the trunk or

hood are opened.You must use a diode

to isolate your hood wire from your

door wire.

6. Connect the Flashing

Parking Light Output: Yellow

wire main harness.

Using a volt/ohm meter, locate the wire

(usually on the head light switch) that

3

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios