Black Widow Security BW X-Z Series Manual de instalación descargar pdf (Pagina 4)

shows 12V+ when only the parking lights

are switched on. European vehicles may

require an additional relay if they have

separate wires that switch on the left and

right side parking lights.

This relayed output has a maximum of 10

amps. Do not hook to head lights. (See

diagram section).

7. Connect 12V+ Power Input:

Red wire on main harness

Connect the red fused wire on the main

harness to a constant 12V+ source.

This source wire should be at least 20

amp supply.There usually is a main con-

stant power wire on the ignition switch.

Use volt/ohm meter to verify.

8. Connect the 12V+ ignition

input: Green wire on main

harness

(Optional)

Connect the green wire on the main har-

ness to a main ignition wire.This can be

also found in the main ignition switch

wire harness.Your volt/ohm meter will

read 12V+ when key is turned on.

Make sure that this ignition wire has

12V+ on even during the starting process

of the vehicle. It is important that the

voltage does not drop when the car is

starting.

Some vehicles have ignition wires that

remain or slowly drop to 0 volts.Verify

that when the ignition is shut off that the

voltage drops to 0 Volts immediately. If

the green wire has voltage on it after the

key is turned off, it will keep the alarm

from arming via the remote.

9. Connect Ground Input:

Black wire on main harness

Locate a good solid chassis ground and

connect to the black wire on main har-

ness.Verify the ground with your

volt/ohm meter.

10. Plug in the main harness to

the module.

11. Test features, functions

and adjust shock sensor.

Arm and disarm system, check that the

siren chirps and parking lights are func-

tioning normally. Make sure that the pro-

grammed features are performing cor-

rectly.

Test the door inputs (make sure that you

check that all doors trigger the system

not just the drivers door).Arm the sys-

tem and try starting the vehicle, it should

not start.

Check for range with the remotes. See

that they arm and disarm all the way

around the vehicle; adjust the module

antenna location if necessary.

Using the remote check for the user fea-

tures: chirp mute, temporary trigger and

bypass.

Deliver the vehicle to customer.

4

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios