Black Widow Security BW 2850 Manual de instalación descargar pdf (Pagina 2)

3 Channel Programmable Features:

Feature # Button One=ON Feature # Button Two=OFF

(1) Car Locator feature ON (parking (1) Car Locator feature OFF

lights stay on 30 sec. after disarm).

(2) Single unlock pulse (2) Double unlock pulse

(3) Red/White wire is 3rd. Channel output (3) Red/White wire is (-) horn output

(4) Channel# 2 normal operation (4) Auto disarm when Ch.# 2 used

Default features are all ON.To change all features to default position enter program mode as

above and press both buttons 1&2 together until siren chirps.

duce a grounded output when system is

armed.

Flashing P

arking Light Output:

Armed: 1 second pulsed, Disarmed: 2-one

second pulses-, then output will latch on

for 30 seconds, or until ignition is turned

on, or system rearms. System triggered: 1

second pulse on, 1 second off, repeated

for 45 seconds.

Dome Light Output

: Output is identi-

cal to Flashing Parking Light Output.

Super Selective

Receiver Board:

The new receiver design allows for a

much narrower band width reception. It

rejects RF interference that causes incon-

sistent range in similar type products and

improves the range of transmission

between remote and receiver.Average

minimum range is 100’ although it is com-

mon to get between 150’-300’. Our

extended range model with windshield

mounted receiver allows for up to 500’ of

range.

Input Zone Out Feature:

If a door input, shock or sensor input

remains on for 4 consecutive cycles (45

seconds) that input will be ignored. If the

input returns to a non-triggered state for

30 seconds it will be monitored by the

system again.

PROGRAMMING FEATURES

3 CHANNEL SOFTW

ARE

UPDATE

All 3 channel platforms have been updated

with new programmable features!

Features that can be programmed are the

following:

1. Parking lights can be programmed to

not stay on after disarm (car locator func-

tion).

2. Double unlock pulses can be added.

3.The 3rd channel can be programmed to

give a pulsing output when alarm is trig-

gered to be connected to the car horn.

4. 2nd channel Auto disarm feature, when

1 2 3 4 5 6 7 ... 15 16

Comentarios a estos manuales

Sin comentarios

Black Widow Security BW 2850 Manual de instalación Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Black Widow Security BW 2850