Black Widow Security BW RAS 100 Manual de instalación descargar pdf (Pagina 7)

PROBABLE SUGGESTED

SYMPTOM CAUSE CORRECTION

Keyless will not go RED or YELLOW wire not connected RED wire should connect directly to

into Code Learning to the correct power source. Code the battery. Connect YELLOW wire to

Mode Learning sequence done to slow. true ignition wire (Not at Fuse Block).

Redo Code Learning sequence faster.

Remote Control does Defective Remote Control. Bad Replace Remote Control or its

not lock and unlock battery. Antenna wire is battery. Unground antenna.

the vehicle. grounded.

Override does not work. Bad switch or switch is not pressed Repair or replace switch or check

long enough to activate the Keyless ignition wire for voltage.

Entry

Flashing output does Bad connection on WHITE Check WHITE wire. Connect

not work. wire or the drive polarity is a SPDT Relay to this wire and

wrong for the circuit being apply the opposite polarity to the

driven. circuit being driven.

Door locks do not Defective GREEN or BLUE Check GREEN and BLUE wires

lock/unlock correctly, wire from door lock connector plug, on door lock connector plug.

or action is reversed. GREEN and BLUE wires on door lock Check vehicle’s door lock

connector plug reversed, or wrong system for method of operation.

door lock wiring diagram used. Reverse wiring to door relays.

752/1/L Rev.7 091997

1 2 3 4 5 6 7

Sin comentarios

Black Widow Security BW RAS 100 Manual de instalación Pagina 7