Black Widow Security BW X-Z Series Información técnica descargar pdf (Pagina 17)

Final Check and Power Up

1. Make a final check to see that all connections have been replaced and

are tight.

2. Close and lock the cabinet door. Remove the key. NOTE: If the door will

not close the monitor may not be positioned all the way back against its

stop.

3. Remove the two throw line stickers from the accessory bag. Attach them

to the floor, one centered on each dart head, at a distance of 98-1/4

inches from the wall. To help the players visualize the left vs right side

playing area, place the three foot adhesive line on the floor as shown

below.

4. Remove the three yellow and black caution stickers from the accessory

bag. Attach them to the floor, directly under the machine, outlining the

cabinet portion of the machine above. These caution lines will remind

the players of the cabinet above while bending over to retrieve a fallen

dart from the floor.

5. Remove the 12 foot power cord from the accessory bag. Plug the cord

into the receptacle on the bottom of the machine and then into a

110VAC GROUNDED outlet.

IMPORTANT: Proper outlet wiring is essential to the operation of this

machine. The wall outlet used must be properly grounded (earth

ground) and the hot/neutral should not be reversed. Have it checked

electrically for proper wiring and grounding. Do not assume a three-

prong outlet is properly wired. Do not cut or alter the power cord from

the machine. Do not use an extension cord unless it is of the heavy-

duty, grounded type.

Installation and Assembly

2.7

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 154 155

Sin comentarios

Black Widow Security BW X-Z Series Información técnica Pagina 17